HVAC and Ventilation

Air Handling Unit Maintenance: A Checklist for Facilities Managers

By Commercial Building Engineering London editorial team · Updated

Quick answer

Air handling unit maintenance typically covers filters, fans, belts and bearings, coils, condensate drains, dampers, heat recovery, sensors and controls. The right frequency depends on the unit, manufacturer guidance, running hours and environment. Site teams can help by reporting noise, alarms, leaks and comfort complaints early, but internal work should be left to competent engineers.

Why AHUs need planned attention

An air handling unit moves, filters, heats or cools air for large parts of a building. Because it runs for long hours and is often out of sight on a roof or in a plant room, problems tend to build up gradually: filters clog, belts wear, drains block and dampers stick. A planned approach catches these before they turn into comfort complaints or failures.

What AHU maintenance usually covers

  • Filters: condition and pressure drop, replacement when needed
  • Fans and motors: noise, vibration, bearings and mountings
  • Belts and pulleys: wear, tension and alignment on belt-driven fans
  • Heating and cooling coils: cleanliness, leaks and valve operation
  • Condensate trays and drains: free draining, no standing water
  • Dampers and actuators: movement matches control signals
  • Heat recovery: wheels, plates or run-around coils operating correctly
  • Sensors and controls: readings plausible, schedules correct
  • Casing and seals: doors close properly, no air leakage

The exact list and frequency should come from the equipment installed, manufacturer guidance, running hours and the environment. See planned preventative maintenance.

What site teams can watch for

Facilities staff are often first to notice a problem. Useful things to report include:

  • New noises, rattles or squeals from the unit
  • Water around the AHU or below ductwork
  • Stuffy areas, draughts or temperature complaints
  • Repeated AHU alarms on the BMS
  • The unit running when the building is closed

Do not open AHU access doors while the unit can run. Fans can start automatically under BMS control. Internal work needs safe isolation by competent people.

When to call an engineer

Call for help if the unit has stopped, if there is a water leak near electrical equipment, if there is a burning smell, or if a fault is affecting ventilation to occupied spaces. For recurring comfort issues, ask for a joint review of the AHU and its controls, as described on our commercial HVAC page.

Questions

How often should AHU filters be changed?

It depends on the filter type, the air quality around the building and how long the unit runs. Pressure-drop readings and manufacturer guidance are better indicators than a fixed calendar date.

Can site staff change AHU filters?

Only if they are trained, authorised and the unit is safely isolated under your site procedures. Fans can start automatically, so isolation is essential.

Useful UK references

General guidance only. It does not replace a qualified site-specific assessment. For gas escapes or carbon monoxide, call the National Gas Emergency Service on 0800 111 999.

Need commercial mechanical engineering support in London?

Call the team or send your enquiry through Flair Facilities Ltd. Share the equipment, the symptoms and the site, and the right engineering discipline can be arranged.